|
Product Details:
|
| Keywords: | Li Ion Battery BMS | Base Material: | FR-4 |
|---|---|---|---|
| Size: | 135MM*58MM*18MM | Copper Thickness: | 1/2OZ 1OZ 2OZ 3OZ |
| Board Thickness: | 2mm | Number Of Layers: | 3 Layers |
| Min. Line Width: | 0.065mm | Surface Finishing: | HASL |
| High Light: | BMS 13S 48V 100A 200A HASL,HASL Lithium Battery Protection Board,135*58*18mm 48v bms board |
||
13S 48V 50A 80A 100A 200A battery software BMS RS 485 RS 232 UART CAN board for li-ion battery pack PCB
1. Our BMS board uses the 3-lay AL board to make it. Better for heat sink
2. High-quality MOS in super low resistance
3. With high withstand voltage. just in order to make more safe protection board for you.
Li-Ion Battery BMS Parameter:
| Model Number | PLNCM-134880 | Product name | Battery Management Systems |
| Place of Origin | Guangdong, China | Application | Battery Packs |
| Brand Name | Passional | Usage | Lithium Battery Packs |
| Base Material | FR-4 | Number of Layers | 3 Layers |
| Copper Thickness | 1/2OZ 1OZ 2OZ 3OZ | Communication | no |
| Board Thickness | 2mm | Size | 135MM*58MM*18MM |
| Min. Hole Size | 0.1mm | Weight | 0.185kg |
| Min. Line Width | 0.065mm | Function | Balance Function |
| Min. Line Spacing | 0.065mm | Color | Silver |
| Surface Finishing | HASL | Material | Aluminum |
FAQ:
Q:1. What type of charger should I choose?
A: Lithium batteries must choose a specific charger, do not use Charger for a Lead-acid battery, for a lead-acid charger may have MOS with high-pressure breakdown protection, which will not protect against BMS overcharge. Life Po4 battery charger voltage=battery string No.X3.6V, while Li-ion battery charger voltage=Battery string No.X4.2V.
Q:2. What current BMS should I choose?
A: Take 10S36V as an example: what current BMS you choose relies on your E-bicycle Motor power and the current limitation of the controller. eg., choose 16A for below 350W, 25A for below 500W, 35A for below 800W, 60A for Below 1000W, higher than 1200W are contact with our service specialist for suggestions, one in all, continue current shall be higher than a current limitation in Controller.
Q:3. Whether my BMS damaged?
A: if you want to judge if the BMS is damaged, please take the following steps, to test if each cell voltage is the same as with the voltmeter. if the cell voltage difference is over 1.0V, the fault is displayed that it cannot run far, no power supply at the start range, short charge time, all these issues are almost caused by battery cells, if BMS damaged is displayed as no charge, no discharge, no discharge while the battery has voltage.
Contact Person: Mrs. Nancy Ouyang
Tel: +86-15889650159
